Energyplus and designbuilder

Forum for DesignBuilder EnergyPlus simulation users to exchange views and questions. Posts regarding use of Detailed HVAC should go to the EnergyPlus HVAC forum

Moderator: DesignBuilder Support

Posts: 1

Energyplus and designbuilder

Postby tana » Thu Jul 05, 2018 4:45 pm

Dear all,

I am working on thesis. I have started with previously found some simulation results that was done in energy plus. So I am using those as base and also for verification as I am using Design builder for my work. I have applied exactly same inputs for all models. But some models shows 0% difference and some shows 10%. But I expected if some show 0% difference, other should show same or close result. Can anyone help why this is happening. I you need more info, I can provide that. Is there any allowable difference when using two different software? For some input I could not use same, but close one.


Return to “EnergyPlus General”

Who is online

Users browsing this forum: No registered users and 11 guests