Tromb wall

Help on setting up the building geometry, including importing from BIM

Moderator: DesignBuilder Support

Posts: 2

Tromb wall

Postby rahnama » Fri Jan 11, 2019 6:25 am

Hello, I dont know how to model vents on one layer of the wall (insulation) like this picture?
tromb 1.jpg
tromb 1.jpg (52.65 KiB) Viewed 414 times
Luis Sousa
Posts: 370
Location: Stroud

Re: Tromb wall

Postby Luis Sousa » Fri Jan 18, 2019 3:58 pm


I believe you will need to model the layers as different partition walls and then draw a Vent object on inner partition representing the insulation layer.


Return to “Geometric Modelling”

Who is online

Users browsing this forum: No registered users and 1 guest