Problem creating partition on boundary of block

Help on setting up the building geometry, including importing from BIM

Moderator: DesignBuilder Support

Posts: 3
Location: Colorado, US

Problem creating partition on boundary of block

Postby VernSmith27 » Fri May 27, 2016 1:43 pm

I'm using an evaluation license of DesignBuilder and I've successfully developed the geometry for a first trial model. I started a second trial model up to the point of creating the first block. When I tried to create the first partition by drawing along the boundary of the block (in either x-axis or y-axis directions) the first point will not set, either by clicking the mouse or by keying in the dimension. If I move the cursor into the block, I can create partitions and set up zones, including ones adjacent to the block boundary by extending the drawing line across the block boundary.

Drawing along the block boundary to start the first partition was easy in the first model and really not possible in the second. I restarted my computer, figuring that perhaps I was out of memory or some other temporary issue existed. The problem re-occurred. Is there a setting that I am not aware of?


Return to “Geometric Modelling”

Who is online

Users browsing this forum: No registered users and 2 guests