I have a problem modelling holes in internal partitions.
First of all they do not want to create themselves. I use "create a hole" tool and it doesn't want to create one. I was able to create two holes, the rest seems to be imposible to create. I want to create the holes to be able to connect zone inside the dormer with the room. A virtual partition would also be a solution, but I don't know how would I be able to set the properties of internal wall to virtual partition. Is there anybody who could help me with that question.
Help on setting up the building geometry, including importing from BIM
Moderator: DesignBuilder Support
1 post • Page 1 of 1
- Screenshot_1.png (414.39 KiB) Viewed 1568 times
- holes_partiton.png (247.02 KiB) Viewed 1568 times
Who is online
Users browsing this forum: No registered users and 3 guests