I am working on thesis. I have started with previously found some simulation results that was done in energy plus. So I am using those as base and also for verification as I am using Design builder for my work. I have applied exactly same inputs for all models. But some models shows 0% difference and some shows 10%. But I expected if some show 0% difference, other should show same or close result. Can anyone help why this is happening. I you need more info, I can provide that. Is there any allowable difference when using two different software? For some input I could not use same, but close one.
Forum for DesignBuilder EnergyPlus simulation users to exchange views and questions. Posts regarding use of Detailed HVAC should go to the EnergyPlus HVAC forum
Moderator: DesignBuilder Support
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 6 guests