Open topic with navigation
Gains data model Option
Data tab
on Model Options dialog.
Gains data
There are three levels of gains model detail:
- Lumped - all internal
gains including occupancy, computer, office equipment, miscellaneous,
catering process and lighting gains are lumped together into a single
value. Solar gains are still calculated in the usual way.Note that with Lumped gains you cannot generate Temperature distribution and Comfort simulation output data.
- Early - gains can
be defined separately under various categories (see above).
- Detailed - gains
are specified by defining each individual item of equipment in each zone
on the Equipment tab. If you select
this option then DesignBuilder will automatically set the Timing
model option to Schedules. Note that
this option was developed for creating very detailed models of existing
buildings based on survey data. Entering this data for a large building
is very time-consuming and in most cases you will be better served by
the Early gains option above. THIS OPTION IS INCLUDED FOR LEGACY MODELS ONLY AND WILL PROBABLY BE DISCONTINUED IN FUTURE.
Note: When using
the Lumped Gains model option, Comfort
data is not generated because in EnergyPlus the request for comfort calculations
is made in the 'PEOPLE' statement and this is not used with Lumped gains.
Lighting gain units
There are 2 ways to define General lighting gains in DesignBuilder:
- Watts per m2 - this used to be the default value in versions pre v2.1, where the General lighting gains are defined as W/m2 independent of the required illuminance level. This method has the advantage that the level of gains can clearly be understood by looking at W/m2 values and floor area. However it can cause problems when loading data from lighting templates (where lighting gains are defined in W/m2/100lux) in that if the activity is changed subsequently with a different illuminance requirement, the lighting W/m2 value is not updated. This led to the introduction of the second option.
- Watts per m2 per 100lux - the default option in v2.1 and later. Although the units W/m2/100lux may seem quite obscure, this method of defining lighting gains has advantages over using W/m2. Namely that the actual lighting level is associated with the lighting system type without the need to refer to the activity and hence illuminance requirement. So if a particular lighting system type is installed throughout a building but the building has a range of activities, it will usually be possible to enter the lighting W/m2/100lux value once only at building level, set the activity for each zone and still get realistic lighting gains. See General lighting gains for details on the calculation of lighting gains from W/m2/100lux, floor area and illuminance requirements.
Occupancy latent gains
There are 2 ways for the sensible-latent split of occupancy gains to be defined:
- Dynamic calculation - where the latent fraction of occupancy gains is calculated within EnergyPlus at runtime based on internal temperatures and metabolic rate.
- Fixed fraction - where the latent fraction of occupancy gains is constant and defined on the Activity tab.