Edit Menu

The Edit menu can be accessed from the horizontal top bar menu at the top of the screen.

Undo <Ctrl+Z> - undo last operation
Redo <Ctrl+R> - redo last operation
End stream <Enter> - end the partition stream creating a floating partition
Cancel current operation <Esc> - cancel the current operation returning to select mode
Undo last point <Esc> - undo the last point drawn when drawing a block base perimeter or when drawing partitions. Note that when drawing arcs, the Undo last point command doesn't undo the whole arc, it operates on one arc line segment at a time. To undo the whole arc, press <Esc> as many times are there are lines in the arc.
Clear to default - clear model data to defaults
Load data from template <Ctrl+L> - loads data from template
Reload templates - reloads data from template throughout model where the template is non-default
Transfer blocks - transfers blocks from one building to another
Convert selected outlines to blocks - convert any selected outlines to component or building blocks
Drag block face -start the drag face operation on the currently selected block
Divide block - divide the currently selected block using the cutting tool
Measure <Ctrl+M> - measure length, angles or areas in the model

Draw block – add a new block (building level only)
Draw internal perimeter- draw a void/courtyard (block level only)
Draw partition - draw partition streams (block level only)
Draw window - draw windows (surface level only)
Draw sub-surface - draw sub-surface (surface level only)
Draw door - draw doors (surface level only)
Draw hole - draw holes (surface level only)
Draw vent - draw vents (surface level only)
Draw construction line - draw one or more construction lines
Place assembly - place an assembly from the library
Flip block surface orientation - applies only to open manifold blocks imported from BIM models